213.805.022
22
Date: 2022-09-19
Manual reset
When the winch is ready, the first thing to do is to reset it. This is done manually in MODE 2 on
DMX channel 6.
Reset example:
The DMX channel 6 is set to 30% the winch starts to roll up the lifting cable.
When the snap hook approaches the motor house, reduce the speed by reducing the DMX
channel 6 input. High speed can damage the winch and lifting cable.
Let it run until the snap hook, at the end of the lifting cable, reaches the motor-house.
The winch is now reset, and the soft TOP limit is at the build-in motor-house top (10 cm below).
If you want to have a lower soft TOP limit, simply just set the DMX channel 6 to 0% and the place
where the winch stops is your new soft TOP limit.
The soft BOTTOM limit is set in the same way, just using DMX channel 7 instead.
Positioning
When the winch has been reset and the soft TOP limit is set, it is possible to use it for positioning
run.
The green LED next to the MODE selector indicates by
Fast flashing
The winch needs to be reset, before it can be used.
Slow flashing
The winch
is moving towards the set position
Steady light
The set position has been reached and the motor has stopped.
The position is set on the DMX channel 1 and 2, which controls the rough-and fine-position.
Where 100 % is the soft TOP limit and 0 % is the soft BOTTOM limit.
The speed is set on the DMX channel 3, where 100 % is the fastest and 0 % is the slowest.
The winch does not run unless the DMX channel 3 is set above zero, and DMX channel 3, therefore
also works as a main brake.
Summary of Contents for Winch 10 Cable
