WAGO TP298, Manual

Page: 7 / 42

7
TP298
Immediately prior to printing a marking strip from the smartDESIGNER, we would like to suggest the
following settings that have been tested by WAGO. In smartDESGNER, please activate the following
settings:
Distance to left edge:
the set position is located left to the
roller cut-out as seen from the front!
Distance of text to left edge:
please reduce this setting to at least "2".
Printing factor:
please correct the value shown above once
in your smartDESIGNER after new installation.
Stretch factor:
this factor only serves as a correction factor for
different lengths of the terminal strips produced.
Please note the detailed description in your
manual.
1.1.2.
WMB Inline preparation
Prior to printing the WMB Inline, please take note of the manual's description of material handling
and print light sensor settings.
1.1.3.
WMB Inline calibration
Upon completion of these steps, you start the printer and tilt the print head lever downward.