WAGO TP298, Manual

Page: 28 / 42

28
TP298
These settings have been tested for the application of a cutting knife (Item No. 258-161). If you do
not use a cutting knife, please activate in item
Cutting the parameter NEVER .
The cutting offset is usually in the range between –1.0 mm and –1.8 mm, depending on the print
head position. Please determine the appropriate offset by conducting test prints. Cutting offset 2 is
usually set to 0 mm.
7.3.
Printer driver settings for WMB Inline
The settings for the print on WMB Inline (2009-115) are shown below, analog to the recommended
settings for marking strip print.
If the ink ribbon begins to tear or shows severe fraying at an early state of
the printing process, the print temperature needs to be lowered.