Important Notes 13
758-919 Wireless Access Point
Manual
Version 1.0.0
2.4
Safety Advice (Precautions)
For installing and operating purposes of the relevant device to your system the
following safety precautions shall be observed:
Always use voltage sources with current limitation/safety extra-low voltage!
Only use power supply sources based on IEC/EN60950 Section 2.5 “Power
sources with limited output” with the device. The output of the external power
supply must be short-circuit protected. The output voltage of the external power
supply shall not exceed 36 VDC.
Do not use device in hazardous environments!
The device is only restricted for use in hazardous areas.
Maintenance/Repair only by authorized specialists!
The device contains no parts that can be serviced by users. Always have all
service, reconfiguration, maintenance or repair work performed by specialists
authorized by WAGO.
Do not work on components while energized!
All power sources to the device shall be switched off prior to performing any
installation, repair or maintenance work.
Keep a distance of 20 cm to persons!
Install the device such that it is located at least 20 cm away from all persons
during operation.
Radio frequency energy emission
This equipment emits RF energy in the ISM (Industrial, Scientific, Medical) band.
Make sure that all medical devices used in proximity to this device meet
appropriate susceptibility specifications for this type of RF energy.
