WAGO I/O System Compact
Appendix 189
751-9301 Compact Controller 100
Manual
Version 1.1.0, valid from FW Version 03.08.07(20)
15.1.1.4.8 “Advanced Intrusion Detection Environment (AIDE)” Page
The network security settings are available on the “Advanced Intrusion Detection
Environment (AIDE)” page.
“Run AIDE check at startup” Group
Table 123: WBM “Advanced Intrusion Detection Environment (AIDE)” Page – “Run AIDE check at
startup” Group
Parameter
Explanation
Service active
Here, you can activate/deactivate the “AIDE check”
when the controller is started.
Click the
[Submit]
button to apply the changes. The changes only take effect
when the controller restarts.
“Refresh Options” group
Table 124: WBM “Advanced Intrusion Detection Environment (AIDE)” Page – “Control AIDE and
show log” Group
Parameter
Explanation
Select Action
Select here the action to be executed.
readlog The log data are displayed.
init
The database is initialized and filled with
the current values.
check
The current values are compared against
the values stored in the database.
update
The current values are compared with the
values stored in the database and the
database then updated.
Read only the last n
Activate display of only the last n messages. You
also specify the number of messages to be
displayed.
Automatic refresh interval
(sec)
Select the checkbox to enable cyclic refresh.
Enter the cycle time in seconds in which a cyclic
refresh is performed. The label of the button
(“Refresh”/“Start“/“Stop”) changes depending on
status.
Click
[Refresh]
to update the display. The button is only displayed if the cyclic
refresh is not enabled.
To enable cyclic refresh, click the
[Start]
button. The button is only displayed if
cyclic refresh is enabled and has not yet started.
To stop cyclic refresh again, click the
[Stop]
button. The button only appears if
cyclic refresh is enabled.
The cyclical refresh is performed for as long as the “Advanced Intrusion
Detection Environment (AIDE)” page is open. If you change the WBM page, the
