WAGO 750-564, Manual

Page: 58 / 102

58 Commissioning WAGO-I/O-SYSTEM 750
750-564 4AO U/I
Manual
Version 1.0.0
7 Commissioning
• Read out module information
• Enable/disable output channels separately
• Connect actuators
• Configure/parameterize output channels
• Calibrate output channels (see also Section “Calibrating Measured Values”
and Section “Service” > “Recalibration”)
• Scale output channels (see also Section “Scaling Measured Values”)
• Read out diagnostic information
• Output process data
• Perform firmware update (see also Section “Service” > “Firmware
Update/Downgrade”)
• Perform firmware downgrade (see also Section “Service” > “Firmware
Update/Downgrade”
The following matrix indicates which tool can be used to make settings on the I/O
module:
Table 49: Settings Using Tools
Settings
e!COCKPIT
WAGO-I/O-
CHECK
GSD GSDML
Channels
enabled/disabled
Output signals
× × × ×
Resolution × × × ×
Process Image × × × ×
Channel diagnostics × × × ×
Synchronous D/A
conversion
× × × ×
Response to K-Bus
timeout
× × - ×
Switch-off delay for K-Bus
timeout
× × - -
User substitute value × × - ×
Scaling × × - ×
Calibration × × - -
Channel diagnostics × × × ×
Diagnosis: power supply
fault
× × - ×
Diagnosis: AO− wiring
error
× × - ×
Diagnosis: wiring error × × - ×
Diagnosis: wire break × × - ×
Diagnosis: short circuit × × - ×
Diagnosis: internal error × × - ×