WAGO 2787-2147, Manual

Page: 29 / 68

2787-2147 Installation and Removal
Product manual | Version: 1.0.0 29
Power Supply Pro 2
5 Installation and Removal
!
NOTICE
Avoid electrostatic discharge!
The products are equipped with electronic components that may be destroyed by electro-
static discharge when touched. Please observe the safety precautions against electro-
static discharge per DIN EN 61340-5-1/-3. When handling the products, please ensure
that environmental elements (personnel, work space and packaging) are properly
grounded.
!
NOTICE
Do not cover the ventilation openings!
To ensure adequate air circulation, the ventilation openings must be kept clear. Maintain
a distance of at least 50 mm from the ventilation openings to adjacent surfaces.
The letters shown in parentheses refer to positions in the “View” figure in section
8
View
[
}
12] .
Mounting Positions
• Nominal mounting position (see also figure under 8 View [ } 12] ): Front side facing for-
wards, marking legible, and bottom ventilation openings facing upwards and down-
wards.
• Never operate the product directly next to other components!
Table 39: Minimum Clearances
Installation Clearances Clearance
Passive adjacent device
(adjacent device does not generate heat)
Above/below 50 mm
On side 6 mm
Active adjacent device
(adjacent device generates additional heat; equivalent product un-
der full load)
Above/below 50 mm
On side 12 mm
DIN-35 Rail
The DIN-35 rail is located in the center of the vertical axis (height) of the product (see
section
8
Technical Data [
}
18] ).