17
W 125
GB
3) Pull out the suction tube with container seal.
4) Turn the union nut (Fig. 7, 1) beyond the lock at level 1 to remove it. Remove the air
cap (2) and pull out the front section of the gun (3). Pull the nozzle (4) out of the front
part of the spray gun.
CAUTION!
Never clean the spray gun with metal objects.
5) Clean all parts carefully using a brush and water or solvent (depending on the material
being processed). Take particular care to ensure that the ventilation hole (Fig. 8) is
clear.
Assembly
1)
1) Insert the nozzle (Fig. 9) into the gun body so that the slots in the nozzle engage in
Insert the nozzle (Fig. 9) into the gun body so that the slots in the nozzle engage in
the gun body's 3 guide rails.
the gun body's 3 guide rails.
2) Put the air cap onto the nozzle and tighten it using the union nut.
3) Place the container seal from below on the suction tube and slide it over the collar,
while turning the container seal slightly.
4) Insert the suction tube with container seal in the gun body.
11. Maintenance
WARNING! Never operate the machine without the air filter; dirt could be
sucked in and interfere with the function of the machine. Disconnect plug
before changing parts.
•
Pull the air filter out of the gun and re-insert cleaned or new air filters (Fig. 10).
12. Spare Parts List
Spare Parts List (Fig. 11)
Pos. Designation
Order No.
1
Spray gun front part complete incl. 600 ml container
2414440
2
Set comprising union nut, air cap, nozzle
2414442
3
Container with cover
2370528
4
Air filter
2414439
13. Correction of Malfunctions
Problem
Problem
Cause
Cause
Remedy
Remedy
No coating
material
emerges from
the nozzle
•
Nozzle clogged
•
Feed tube clogged
•
Material volume too small
•
No pressure build-up in container
•
Clean
•
Clean
•
Increase the material
volume
•
Tighten container
