WAGNER U580.00, Translation Of The Original Operating Manual, Page: 29 / 52

29
Unica 4-270
.
OPERATING MANUAL
EDITION 04 /2007 PART NO. ZZB006ENG
5.3
FINISHING WORK AND CLEANING
Note
The device should be cleaned for maintenance purposes, etc. Ensure that no remaining
material dries and sticks.
Procedure:
1. Follow the procedure foreseen to stop the pump -> chapter 5.2.5
2. Follow the procedure foreseen for washing -> chapter 5.2.3.
3. Clean and check the suction system and, in particular, the suction fi lter.
4. When using a high-pressure fi lter: Clean and check the fi lter insert
5. Clean the outside of the system.
6. Fill the system with detergent following the instructions given in paragraph 5.2.4
“Filling with working fl uid”.
7!2.).'
"RITTLElLTERPRESSUREREGULATOR
4HE CONTAINER ON THE lLTER PRESSURE REGULATOR BECOMES BRITTLE
THROUGHCONTACTWITHSOLVENTSANDCANBURST
&LYINGPARTSCANCAUSEINJURY
œ $ONOTCLEANTHECONTAINERONTHEPRESSUREREGULATORWITHSOL
VENT
3)()??'"
7!2.).'
'ASMIXTURESCANEXPLODEIFTHEREISANINCOMPLETELYlLLED
PUMP
$ANGERTOLIFEFROMmYINGPARTS
œ %NSURE THAT THE PISTON PUMP AND SUCTION SYSTEM ARE ALWAYS
COMPLETELYlLLEDWITHCLEANINGAGENTORWORKINGMEDIUM
œ $ONOTSPRAYTHEUNITEMPTYAFTERCLEANING
3)()??'"
5.4
STORING FOR LONGER PERIODS OF TIME
When storing the device for longer periods of time it is necessary to thoroughly clean it
and protect it from corrosion. Replace the water or the solvent in the pump delivery circuit
with a suitable preservative oil.
Procedure:
1. Carry out Paragraph 5.3 „Shutting down and cleaning“, points 1 through 6.
2. Fill the system with conservative liquid following the instructions given in paragraph
5.2.4.
3. Protect the air motor with pneumatic oil: connect an oiler to the compressed air inlet
and run for a few double strokes.