46
Super Finish 17ex
GB
CLEANING THE UNIT / SERVICING
8.1
CLEANING THE UNIT FROM THE OUTSIDE
Never spray down the unit with high-pres-
sure or high-pressure steam cleaners.
Do not put the hoses into solvents. Use only
a wet cloth to wipe down the outside of the
hose.
Wipe down unit externally with a cloth which has been im-
mersed in a suitable cleaning agent.
8.2
SUCTION FILTER
Clean filters always ensure maximum volume,
constant spray pressure and problem-free
functioning of the unit.
Unit with suction system
1. Unscrew the filter (Item 1) from the suction hose.
2. Clean or replace the filter.
Carry out cleaning with a hard brush and a corresponding
cleaning agent.
8.3
HIGH-PRESSURE FILTER
1.
Switch off unit – set multifunction switch to
0
(OFF).
2. Open the high-pressur
e filter and clean the filter insert. To
do so:
3. Unscrew the filter housing (1) by hand.
4. Remove the filter insert (2) and pull out the bearing spring
(3).
5. Clean all the parts with the corresponding cleaning agent.
If compressed air is available – blow through the filter insert
and bearing spring.
6. When mounting the filter ensure that the bearing ring (4) in
the filter insert is positioned correctly and check the O-ring
at the filter housing for damage.
7. Screw on the filter housing by hand until it stops (a higher
tightening force only impedes later dismantling).
1
2
suction system
5l hopper
Unit with hopper
1. Release screws with a screwdriver (Item 2).
2. Lift and remove filter disk with a screwdriver
3. Clean or replace the filter disk.
Carry out cleaning with a hard brush and a corresponding
cleaning agent.
1