WAGNER ProfiTech M, Original Operating Manual

Page: 4 / 108

4
ProfiTech M
OPERATING MANUAL
VERSION 07/2014 ORDER NUMBER DOC 2335144
Table of Contents
6.11 Miscellaneous 31
6.12 Technical Data 32
6.12.1 MCM Master Control 32
6.12.2 MCM CPS I/O Control 33
6.12.3 Technical Data for Maximum Profi Tech M Confi guration 34
6.12.4 Rack (10 EPG S2) 35
6.12.5 EPG S2 35
6.12.6 EPG-Sprint X 36
6.13 Compressed Air Quality 37
6.14 Operating Elements on the Master Module 38
6.15 Display Elements Front Side of EPG S2 39
7 ASSEMBLY AND COMMISSIONING 40
7.1 Training the Assembly Staff 40
7.2 Storage Conditions 40
7.3 Installation Conditions 40
7.4 Assembly of the Profi Tech M Components 41
7.5 Setting Up the Rack 42
7.6 System Description 43
7.6.1 CPS Control Cabinet Design 43
7.6.2 Terminal Descriptions 44
7.6.3 CAN Addresses for MCM System 47
7.7 Connecting the MCM Module 48
7.7.1 Connections on the MCM Master Control 49
7.7.2 Connections on the MCM CPS I/O Control 49
7.7.3 Connection Point for CAN Bus, EPG-Sprint X and Encoder 50
7.8 Connections in the Rack 51
7.9 Connecting the Automatic Spray Guns on the EPG S2 52
7.10 Connecting the Manual Guns to the EPG-Sprint X 53
7.10.1 Signals on the EPG-Sprint X 54
7.10.2 Parameter Setting on the EPG-Sprint X 54
7.11 Power Supply of the EPG Control Units 55
7.12 Connecting the Conveyor Encoder 56
7.13 Connecting the Light Curtains 57
7.13.1 Connection Diagram for "Kontur 2" Light Curtains 57
7.13.2 Installation of the "Kontur 2" Light Curtains 59
7.13.3 Connection Diagram for LGS Light Grid 61
7.13.4 Assembly of CML720i Light Curtains 62
7.13.5 Connection Diagram for CML720i Light Curtains with Code Catching 64
7.13.6 Connection Diagram for CML720i Light Curtains without Code Catching 66
7.13.7 Connection Diagram for CML720i Height Light Curtains 67
7.13.8 Grounding of CML720i Light Curtains 68
7.14 Commissioning the CML720i Light Curtains 69
7.14.1 Setting the Baud Rate 72
7.14.2 Setting Node ID 74
7.14.3 Alignment Operation 76
7.15 Connection of the Motion Technique 78
7.15.1 Connections with Two Motion Units 79
7.15.2 Connections with Four Motion Units 80
7.15.3 Setting Node ID's and Baud Rate on Sliding Table 81