29
GM 4700AC
B_00071
OPERATING MANUAL
VERSION 06/2014
ORDER NUMBER DOC2311730
7.3
WORK
Spray pattern shapes:
No atomizing air
Too little atomizing air
Correct amount of atomizing air
Note:
The quantity of product can be changed by:
- changing the product pressure or
- using a diff erent fl at jet nozzle (see Chapter 7.3.4 and Chapter 13).
7.3.1
STARTING TO SPRAY WITH THE AIRCOAT
1. Start up with product supply set to approx. 8 MPa; 80 bar; 1160 psi operating
pressure.
2. Spray (release locking device and pull trigger) and at the same time observe how
the product is atomizing.
3. Set the fl uid pressure on the material pump to a point where good product
atomization is achieved.
4. Open the air pressure regulator for the atomizing air and adjust it so that an optimal
atomization is achieved. (The interrelation between spray pattern and atomizing air
is shown in the fi gure below).
5. Use the shaping air controller on the gun to adjust the shaping air to atomizing air
ratio until the optimal spray pattern is achieved.
Note:
Repeat points 3, 4 and 5 until the optimum spray pattern is reached (iterative process).
Ensure that:
the regular safety checks are carried out in accordance with Chapter 8.2.3,
commissioning is carried out in accordance with Chapter 6.8.
Summary of Contents for GM 4700AC
Page 2: ......
Page 55: ...55 GM 4700AC 55 GM 4700AC OPERATING MANUAL VERSION 06 2014 ORDER NUMBER DOC2311730...
Page 79: ......
