FineCoat 7000 S
14
GB
Preparing the coating material
Observe the manufacturer’s instructions for the use of the
coating material on the paint tin or on the technical instruc-
tion sheet.
Coating material purity:
An absolute pre-condition for the trouble-free operation of
the fine-spray system is that the coating material is uncon-
taminated. If you have doubts as to the purity of the coating
material, we recommend that you first filter it through a fine
sieve.
Table of viscosities and nozzle sets
Coating material
Viscosity DIN-s
(4 mm DIN cup)
Nozzle set
No.
Solvent-based
lacquer paints
15 - 45
3 - 4
Water-soluble
lacquer paints
observe manufac-
turer's instructions
4 - 5
Wood preservatives
(scumble, mordants,
etc.)
undiluted
2-3
Multi-color effect
materials, multi-color
paint
observe manufac-
turer's instructions
6-7
Texture and effect
paints
observe manufac-
turer's instructions
5-6
Starting operation
Before connecting to the mains supply make sure that the
mains voltage corresponds to the operating voltage on the
rating plate. The unit must be connected with a properly
earthed shockproof socket.
Screw air hose end (anti-kink spring) onto the turbo-blower.
1.
Couple air hose to the paint spray gun.
Open closing lever on the paint container, remove paint
2.
container.
Fill paint container with coating material.
3.
Check that the paint container seal is clean and is seated
4.
correctly.
Clip the container onto the spray gun and secure with the
5.
closing lever.
Switch the turbo-blower on.
6.
Point the paint spray gun at the object to be sprayed.
7.
8. Determine the settings for the spray pattern, spray jet
width, amount of material, amount of air and ascending
feed pipe settings, see fig. 2 - 8 and the description page
14/15.
Operate trigger on the paint spray gun..
9.
Setting the FineCoat spray gun
Spray pattern selection (fig. 2)
A = vertical flat jet for horizontal surfaces
B = horizontal flat jet for vertical surfaces
C = round jet for corners and edges and places difficult to
access.
Setting the required spray pattern (fig. 3)
Turn the air cap (1) to the required spray pattern position.
Attention:
Never pull trigger while adjusting the air cap settings.
1
