WAGNER Cobra 40-10/2K, Translation Of The Original Operating Manual

Page: 46 / 80

46
B_04246
17 mm;
0.67in
8
7
4
9
5
6
3
B_05071
OPERATING MANUAL
VERSION 07/2014
ORDER NUMBER DOC2349980
Filling hydraulic stage with oil
Procedure:
1 Place the pump upside down on a suitable pad. Align horizontally.
2 Unscrew and remove threaded plug (5).
3 Unscrew 2 locking screws (4) and replace with 2 screw fi ttings (6) from the oil fi lling
set.
4 Connect hoses with Y-pieces (7).
5 Fill syringe (8) with hydraulic oil and insert into hose.
6 Move piston (9) into front end position. Use the syringe to fi ll the hydraulic stage until
the oil fl ows out of the suction fi tting into the oil tank (3) with no air bubbles.
7 Move piston (9) into rear end position. Use the syringe to fi ll the hydraulic stage until
the oil fl ows out of the suction fi tting into the oil tank (3) with no air bubbles.
8 Continue to top up the oil until the level before venting is approx. 17 mm; 0.67 inches
below the upper edge of the oil tank.
9 Screw in threaded plug (5) and tighten gently. Put pump on its side and dismount oil
fi lling set. Seal the fi ller openings tightly with 2 locking screws (4).
Environmental pollution caused by waste oil!
Waste oil in the sewage network or spilled on the ground causes
severe environmental damage.
Groundwater pollution is liable to prosecution.
Collect waste oil and bring it to a collection point.
Waste oil is taken back by the seller when purchasing hydraulic
oil.
CAUTION