WAGNER Cobra 40-10/2K, Translation Of The Original Operating Manual

Page: 14 / 80

14
OPERATING MANUAL
VERSION 07/2014
ORDER NUMBER DOC2349980
4.2.1
SAFE HANDLING OF WAGNER SPRAY DEVICES
4.2
SAFETY INSTRUCTIONS FOR STAFF
Always follow the information in these instructions, particularly the general safety
instructions and the warning instructions.
Always follow local regulations concerning occupational safety and accident
prevention.
The spray jet is under pressure and can cause dangerous injuries.
Avoid injection of paint or fl ushing agents:
Never point the spray gun at people.
Never reach into the spray jet.
Before all work on the device, in the event of work interruptions and functional faults:
- Switch off the energy/compressed air supply.
- Relieve the pressure from the spray gun and device.
- Secure the spray gun against actuation.
- In the event of functional faults, remedy the fault as described in the "Troubleshooting"
chapter.
When necessary, or at least every 12 months, the liquid ejection devices should be
checked for safe working conditions by an expert (e.g., Wagner Service Technician)
in accordance with the guidelines for liquid ejection devices (ZH 1/406 and BGR 500
Part 2 Chapter 2.29 and 2.36).
- For shut down devices, the examination can be suspended until the next start-up.
Follow the "Pressure Relief Procedure":
- If pressure relief is required.
- If the spraying work is interrupted or stopped.
- Before the device is cleaned on the outside, checked or serviced.
- Before the spray nozzle is installed or cleaned.
In the event of skin injuries caused by paint or fl ushing agents:
Note the paint or fl ushing agent that you have been using.
Consult a doctor immediately.
Avoid risk of injury from recoil forces:
Ensure that you have firm footing when operating the spray gun.
Only hold the spray gun briefl y in a position.