![background image](http://html2.mh-extra.com/html/waferlock/c760/c760_user-manual_3060383004.webp)
Standalone Mode Programming Instruction
1. There is only one combination to unlock the cylinder.
If new code is programmed successfully, the existing
one will be replaced.
2. The default combination is 123456. This code will be
able to unlock the cylinder before it is programmed.
Note
Touch the
WAFERLOCK
logo for 1 second
until the orange light flashes 2 times.
Rotate the knob with the number to the twelve
o’clock position, the number will blink. Once the
light is steady, it means the number is chosen.
After 4-6 digits are correctly chosen, rotate
the knob with # to the twelve o'clock position
until the numbers flash in order 2 times.
The combination is programmed.
Tap the programming card on the cylinder 1 time.
Program The Combination
1
2
3
4
1
se
c
Orange X 2
Progr
amming
To open:
Tap the user card on the reader,
it will unlock the door with 1 beep and the
green light flashes 1 time.
Unlock With A User Card
The maximum user cards/badges are 2,000.
If reaching the maximum limit, there will be 10 short
beeps with red light alternately flashing 3 times.
Note
1
User Car
d
Green X 1
1 “beep” sound
To add a new user:
Tap the programming card
on the reader. There will be 2 beeps, and the
green light starts flashing. Tap the user card on
the reader, and there are 3 beeps. The
programming session will be complete until 2
beeps and red light flashes 2 times.
Program A User Card
1
1. Please remember to set up the programming
card, referring to former instruction.
2. If 2 short beeps occur with the red light flashing
2 times, the setup was not successful. Please
re-do the step again.
Standalone Mode programming functions
(Programming Card) are NOT available after
the lock is paired with mobile App!
If you would like to use Standalone Mode,
please unpair the lock via
WAFERKEY
App.
WARNING
Progr
amming
User Car
d
Green
2 “beep” sound
3 “beep” sound
Note
1. Program multiple users: The green light will keep
flashing for around 10 seconds after 3 beeps
which allow you to program multiple user cards
constantly.
2. Tap the programmed user card while the green
light flashing will complete the programming
session (instead of waiting for 10 seconds flashing
green light).
Note