SinePower
Fastening the inverter
25
6
Fastening the inverter
You can fasten the inverter using the four holders supplied.
When selecting the installation location, observe the following instructions:
z
The inverter can be mounted horizontally or vertically.
z
The inverter must be installed in a place that is protected from moisture.
z
The inverter may not be installed in the presence of flammable materials.
z
The inverter may not be installed in a dusty environment.
z
The place of installation must be well-ventilated. A ventilation system
must be present for installations in small, closed spaces. The minimum
clearance around the inverter must be at least 25 cm (fig.
1
, page 3).
z
The air intake on the underside or the air outlet on the back side of the
inverter must remain clear.
z
For ambient temperatures higher than 40 °C (such as in engine or heating
compartments, or direct sunlight), the heat from the inverter under load
can lead to the automatic shut-off of the inverter.
z
The installation surface must be level and sufficiently strong.
a
Caution
Before drilling any holes, ensure that no electrical cables or other
parts of the vehicle can be damaged by drilling, sawing and filing.
Fasten the inverter as follows (fig.
3
, page 4):
➤
Clip two holders on the lower left bar and two on the right.
You can move the holders as required.
➤
Fasten the inverter by screwing one screw through each hole in the
holders.
_MSP160_MSP350.book Seite 25 Montag, 5. November 2007 4:49 16
