Safety instructions
SinePower
22
2.2
Safety when installing the device
z
Ensure the device is standing firmly.
The device must be set up and fastened in such a way that it cannot tip
over or fall down.
z
Take the precautions necessary to ensure that children cannot interfere
with operation. Dangerous situations may occur which cannot be recog-
nised by children!
z
Do not expose the device to a heat source (such as direct sunlight or heat-
ing). Avoid additional heating of the device in this way.
For installation on boats
z
If electrical devices are incorrectly installed on boats, corrosion damage
might occur. Have the inverter installed by a specialist (marine) electri-
cian.
Electrical cables
z
If cables have to be fed through metal walls or other walls with sharp edg-
es, use ducts or wire bushings to prevent damage.
z
Do not lay cables which are loose or bent next to electrically conductive
material (metal).
z
Do not pull on the cables.
z
Do not lay the 230 V mains cable and the 12/24 V DC cable in the same
duct.
z
Fasten the cables securely.
z
Lay the cables so that they cannot be tripped over or damaged.
2.3
Operating the appliance safely
z
Operate the device only if you are certain that the housing and the cables
are undamaged.
z
Make sure the air inlets and outlets of the device are not covered.
z
Ensure good ventilation.
z
Do
not
connect the 230 V output of the inverter (fig.
1
3, page 3) to a
different 230 V source.
_MSP160_MSP350.book Seite 22 Montag, 5. November 2007 4:49 16
