Waeco PerfectView M55LX, Installation And Operating Manual

Page: 26 / 256

Safety and installation instructions PerfectView M55LX, M75LX
EN
26
If you disconnect the negative terminal of the battery, all data stored in the volatile
memories will be lost.
 The following data must be reset, depending on the vehicle equipment options:
– Radio code
– Vehicle clock
– Timer
– On-board computer
– Seat position
You can find instructions for making these settings in the operating manual.
Observe the following installation instructions:
!
Observe the following instructions when working with electrical parts:
 When testing the voltage in electrical cables, only use a diode test lamp (fig. 1 1,
page 3) or a voltmeter (fig. 1 2, page 3).
Test lamps with a bulb (fig. 1 3, page 3) consume voltages which are too high and
can damage the vehicle's electronic system.
 When routing the electrical connections, ensure that:
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp-edged ducts without protection (fig.
3 , page 4).
 Insulate all connections.
 Secure the cables against mechanical wear by using cable binders or insulating tape,
for example on existing cables.
Observe the following instructions when handling the LCD monitor:
!
CAUTION!
 Secure the monitor in such a way that it cannot become loose under any cir-
cumstances (sudden braking, accidents) and cause
injuries to the occu-
pants of the vehicle.
 Do not attach the monitor in the air bag deployment path, as this could cause
injury if the airbags are triggered.
CAUTION!
 People (including children) whose physical, sensory or mental capacities or
whose lack of experience or knowledge prevent them from using this prod-
uct safely should not use it without the supervision or instruction of a respon-
sible person.
 Do not open the monitor (fig. 4 , page 4).

Do not submerge the monitor in water (fig. 5 , page 4); the monitor is not
waterproof.
 The monitor must not impair your vision when driving (fig. 8 , page 5).

Do not operate the monitor with wet hands.
 Do not operate the monitor if the housing has been damaged.