Waeco PerfectView CAM44, Installation And Operating Manual

Page: 24 / 27

EN
Fitting the camera
PerfectView CAM44
44
8.5 Connecting the AMP100 switchbox
(fig.
o , page 10)
I
NOTE
If you would like to use both camera modules when driving for-
wards, you will need to fit the flip switch supplied (see the installa-
tion and operating manual for AMP100).
The switch box (not included in delivery) is ready for installation.
➤
Mount the switchbox as described in the corresponding installation and
operating manual.
I
NOTE
Output “2” on the switchbox is an auxiliary output, e.g. for connect-
ing an external monitor.
➤
Connect the switchbox electrically as described in the corresponding in-
stallation and operating manual.
8.6 Checking the function and setting the camera
I
NOTE
The distance values of the distance markers (see chapter “Estimat-
ing distances” on page 45) only apply when the camera is installed
at a height of approx. 230 – 250 cm.
Check the actual installation height once you have installed the
camera.
If the installation height deviates from these values, determine the
actual distance values for the distance markers.
➤
Check the function of the camera after you have connected it to a monitor.
➤
Align the camera using the image on the monitor to help you:
The monitor image should show the rear or the bumper of the vehicle at
the bottom edge of the screen. The middle of the bumper should be in
the middle of the screen (fig.
m , page 9).
➤
Tighten the four fastening screws of the camera.
➤
Place the side covers on and secure each one with a fastening screw
(fig.
l , page 8).
Settings for contrast and brightness can be made on the monitor.
_CAM44.book Seite 44 Mittwoch, 7. März 2012 10:15 10