Waeco PerfectView CAM44, Installation And Operating Manual

Page: 23 / 27

EN
PerfectView CAM44
Fitting the camera
43
8.3 Connecting the camera
I
NOTE

Lay the camera cable so that should you need to remove the
camera, you can access the plug connection between the
camera and the extension cable easily. This considerably
eases dismantling work.
 To minimise corrosion in the plug, apply a small amount of
grease – such as pin grease – inside the plug.
➤
Guide the camera cable into the vehicle interior.
➤ Insert the plug of the camera cable into the socket of the extension cable.
➤
Screw on the plug connections of the connecting cables to protect against
water penetration (fig.
0 , page 5).
8.4 Connecting the 9012000078 switchbox
(fig.
n , page 9)
The switchbox is supplied ready for installation.
➤
Fasten the switchbox at a suitable point.
➤
Connect the control box electrically as follows:
– Connect the camera inputs on the monitor to the “V1” and “V2”
connections.
– Connect the system cable from the camera to the “TWIN” connection.
The camera is switched on and off in reverse gear or using the camera
selection button on the monitor.
_CAM44.book Seite 43 Mittwoch, 7. März 2012 10:15 10