Waeco PerfectView CAM44, Installation And Operating Manual

Page: 17 / 27

EN
PerfectView CAM44
Notes on the electrical connections
37
 Protect every through-hole made in the bodywork against water penetra-
tion, e.g. by using a cable with a sealant and by spraying the cable and
the the cable sleeve with sealant.
I
NOTE
Only start sealing through-holes when you have completed all in-
stallation work on the camera and have laid the required cable
lengths.
7.2 Using branch connectors
To prevent loose connections in the branch connectors, it is important to en-
sure that the cable cross sections fit into the branch connectors.
To use the branch connectors, proceed as follows:
➤
Insert the cable to be tapped in the front groove of the cable connector
(fig.
a A, page 6).
➤
Insert the end of the new cable up to approx. 3/4 of the way into the rear
groove (fig.
a B, page 6).
➤
Use a pair of combination pliers to close the connector by pressing the
metal pin in. This creates an electrical connection (fig.
a C, page 6).
➤
Press down the safety cap until it snaps into place.
➤
Check that the connection is secure by gently tugging the cable (fig. a D,
page 6).
7.3 Creating clean soldering joints
Proceed as follows to solder a cable to the original cables:
➤
Strip approx. 10 mm of insulation from the end of the original cable
(fig.
b A, page 6).
➤
Strip approx. 15 mm of insulation from the end of the cable to be connect-
ed (fig.
b B, page 6).
➤
Wind the cable to be connected around the original cable and solder the
two cables together (fig.
b C, page 6).
➤
Insulate the two cables with insulating tape (fig. b D, page 6).
_CAM44.book Seite 37 Mittwoch, 7. März 2012 10:15 10