magic watch
Installing MAGIC WATCH
37
The DSM function ensures that objects attached to the vehicle (such as
trailer couplings) are not classified as obstacles. As a rule they do not
protrude more than 0.4 m over the sensors. They are therefore in the close
area (zone 3) of up to 0.4 m, in which MAGIC WATCH gives a stop warning
and where you should stop (see the section on “Performing a functional test”
on page 44).
Caution!
If loads or objects on the vehicle protrude over the close area of 0.4
m, there is a danger of accidents. An obstacle can collide with the
load or the object before it is detected by the sensors in the close
area and before MAGIC WATCH gives a stop warning (see
a
,
page 6).
6
Installing MAGIC WATCH
6.1
Tools required
For
installation and assembly
you will require the following tools:
z
Drill bit set (see
1
1, page 3)
z
Drill (see
1
2, page 3)
z
Screwdriver (see
1
3, page 3)
z
Set of ring or open-ended spanners (see
1
4, page 3)
To make and test the
electrical connection
, the following tools are required:
z
Diode test lamp (see
1
5, page 3) or voltmeter (see
1
6, page 3)
z
Crimping tool (see
1
7, page 3)
z
Insulating tape (see
1
8, page 3)
z
Cable bushing sleeves, if necessary
To
fasten the control box and the cable
you may require additional screws
and cable binders.
MWE-850-XXL-4.book Seite 37 Freitag, 8. Juli 2005 10:29 10
