Installing MAGIC WATCH
magic watch
40
z
Note that the installation angle depends on the installation height
(
b
and
c
, page 7).
z
The installation location should be as flat as possible.
z
Fit the sensors at regular intervals along the total width of the vehicle in
order to guarantee optimum monitoring (
d
, page 7).
Note that the sensors must be aligned in a particular direction. The top
side of the sensor is labelled with “
▲
” (
e
, page 7).
z
So that the corners of the vehicle (indicators etc.) can be monitored, the
outer sensors must be fitted as far as possible to the left and right (
d
,
page 7).
z
It is possible to paint the sensors, but
not with a multicoat paint
, as this
impairs the functionality of the sensors.
Installing the MWE-1000-4FM
To perform the installation, proceed as follows:
➤
Choose an installation location on the bumper which is as perpendicular
to the road surface as possible (
e
, page 7).
Caution
Before making any drill holes, ensure that no electrical cables or other
parts of the vehicle can be damaged by drilling, sawing and filing.
➤
For each sensor, drill a hole with a diameter of 24 mm in the bumper.
➤
Remove the hex nut and the outer spacer ring of the sensor.
➤
Guide the cables of the sensors through the corresponding hole.
➤
Insert each sensor into its hole and fasten it by putting on the spacer ring
and screwing the nut onto the sensor thread behind the bumper.
Installing the MW-1000-4FM
To perform the installation, proceed as follows:
➤
Choose an installation location on the bumper which is as perpendicular
to the road surface as possible (
f
, page 7).
Note
The surfaces to be bonded must be clean, dry and free of grease.
➤
Pull the protective foil from the adhesive tape for each sensor, and fasten
the sensors.
_MWE-1000-4FM.book Seite 40 Dienstag, 9. August 2005 11:30 11
