DIY-12
Programming the alarm system
39
10.3
Setting the voltage monitoring
➤
Disarm the alarm system.
➤
Switch the ignition on and off four times.
➤
Switch on the ignition again within eight seconds.
✓
The alarm siren sounds two signals after eight seconds.
✓
You are now in setup mode and can adjust the voltage monitoring.
Setting the time delay
You select one of two settings:
– 8 seconds
– 4 minutes
➤
In voltage monitoring setup mode, press the
ON/OFF button
.
✓
The alarm system indicates the setting.
– 1 signal tone: 8 seconds time delay (default setting).
– 2 signal tones: 4 minutes time delay.
➤
If you want to change the delay setting, press the
ON/OFF button
again.
✓
A signal sounds.
Activating and deactivating voltage monitoring
➤
In voltage monitoring setup mode, press the
P button
.
✓
The alarm system indicates the setting.
– 1 signal tone: voltage monitoring is activated.
– 2 signal tones: voltage monitoring is deactivated (default setting)
➤
If you want to change the setting, press the
P button
again.
✓
A signal sounds, unless this function has been deactivated.
DIY-12.book Seite 39 Freitag, 24. Februar 2006 3:51 15
