Waeco CR-50, Operating Manual

Page: 49 / 344

EN
CoolMatic Using the refrigerator
49
Defrosting the freezer
A
To defrost the refrigerator, proceed as follows:
➤
Take the contents out.
➤
If necessary, place the contents in another cooling appliance, to keep
them cool.
➤
Set the temperature control knob to “0”.
➤
Leave the door open.
Switching off and storing the refrigerator
If you do not intend to use the refrigerator for a long time, proceed as follows:
➤
Set the temperature control knob to level “0”.
➤ Disconnect the power cable from the battery or pull the AC cable plug out
of the rectifier.
➤
Clean the refrigerator (see chapter “Cleaning and care” on page 50).
➤
Turn the locking wheel (fig. 9 1, page 6) anti-clockwise to the end stop
(“Vent”).
➤
Close the door until it latches in.
✓
The door stays open thus preventing smells from arising.
Replacing the interior light
If the interior light in the refrigerator is faulty, you can change the LED lamp
(DC 12 – 24 V, 0.3 W). When changing the lamp, only use LEDs which can
be run with
12 V and 24 V .
➤
Remove the cover.
➤ Pull the lamp (fig.
6
4, page 5) out of the sheet metal straps.
➤
Slide in the new lamp between the sheet metal straps, until it snaps into
place.
NOTICE!
Never use mechanical tools to remove ice or to loosen objects
stuck to the device. The only exceptions are devices approved for
the purpose by the manufacturer.