Waeco 9103303105, Operating Manual

Page: 20 / 254

EN
10.
Confirm the new user code:
ADM AREA
User number
1
Confirm new code
----
Note To switch between upper and lower case use the yellow Info key.
11.
Enter the user name and press
ENTER
to confirm:
ADM AREA
User number
1
User name
John Citizen
ADM AREA
User number
1
John Citizen
The user is created and the menu changes again to the user selection.
12. Proceed as follows:
• Create another user by using the cursor keys to select
Database
and proceed as described.
•
To exit the menu press
STOP
.
13.3.2 Entering user codes
If a user code has been created, the same code must be used to enable the A/C service unit.
Enter the user code.
ENTER USER CODE
----
If you enter an incorrect user code, the following error message appears:
WRONG CODE
Once the correct code is entered, the A/C service unit is enabled and starts up. The user's name is displayed:
John Citizen
13.4 Creating a personal database
You can enter up to 100 customer-specific vehicles with the corresponding filling quantities in this database. The
personal entries are saved in the control board, not on the flash memory card. The entries will be retained even
after updating the software. The entries are stored chronologically, not alphanumerically.
1.
In the basic menu use the cursor keys or to select
Short selection
.
Short selection
Free selection
Other selections
ENTER-OK
2. Press ENTER to confirm.
20