WACO VC1803, User Manual

Page: 12 / 38

Dehumidifier does
not dry the air as it
should
•
Not enough time allowed for unit to
remove moisture.
•
When first installed, allow at least 24 hours
to maintain the desired dryness.
•
Airflow is restricted.
•
Make sure there are no curtains, blinds, or
furniture blocking the front or back of the
dehumidifier. See the CHOOSING A
LOCATION section.
•
Dirty filter.
•
See the CLEAN FILTER section.
•
The Humidity Control may not be set low
enough.
•
For drier air, choose lower humidity
desired in the room, or set dry mode or
continuous mode.
•
Doors and windows may not be closed
tightly.
•
Check that all doors, windows, and other
openings are securely closed.
•
Clothes dry may be the room
•
Install the dehumidifier away from the
dryer. The dryer should be vented outside
the room.
•
Room temperature is too low.
•
Moisture removal is best at higher room
temperatures. Lower room temperatures
will reduce the moisture removal rate. This
model is designed to operate at
temperatures above 5°C.
Water on the floor
•
Hose connection may be loose.
•
Check the hose connection. See the
CONTINUOUS MODE Section.
•
Hose is attached but not draining.
•
Disconnect the hose if using the water
tank, or place the hose near a drain.
WARRANTY
Dear Customer,
All our products are subject to strict quality control before they are sold. However, if the device does not work as it
should, we sincerely regret it. In this case, we kindly request you to contact our customer service. Our employees
will be happy to help.
This device has a warranty period of 2 years from the date of purchase. During the warranty period, the
manufacturer accepts full responsibility for failures that are obviously due to material or construction defects. If such
defects occur, the device will be repaired or replaced as necessary. The warranty period of 2 years does not start at
this moment again, but it continues until 2 years after the date of purchase. The guarantee is provided on the basis
of a proof of purchase. The warranty will not be valid when the damage to the appliance is caused by wrong use,
not following the instructions or repairs executed by a third party.
The warranty and liability of the supplier and manufacturer lapse automatically in the following cases:
If the instructions in this manual have not been followed.
In case of incorrect connection, e.g. too high or too low voltage.
In case of improper, rough or abnormal use.
In case of insufficient or incorrect maintenance.
In case of repair or alteration of the device by the consumer or unauthorized third parties.
If the customer used parts or accessories that are not recommended or provided by the manufacturer.