Wacker Neuson PSA2 500, Operator'S Manual, Page: 14 / 60

Installation PS2 500 / PSA2 500
14
wc_tx001592gb.fm
3.2 Preparing the Machine for First Use
When the pump is delivered, first perform the following inspection
checks:
•
While unpacking, inspect the product for damage during
shipment, and make sure all bolts and nuts are tightened
properly.
• Check the model number to make sure it is the product that was
ordered. Be certain it is the correct voltage and frequency.
Note: If there is any problem with the product as shipped, contact
your nearest dealer or Wacker Neuson representative at once.
3.3 Application Area
If the pump is used for outdoor fountains, garden ponds and similar
places, or to drain a swimming pool, the pump must be supplied by an
isolating transformer or connected to a Residual Current Device
(RCD) with a residual operating current not exceeding 30 mA.
The pump must not be used when people are in the water.
Leakage of pump lubricants may cause pollution of water.
Proper plug must be provided according to local codes and standards.
Refer to wiring diagram.
Do not use this pump in liquids other than water, such as oil, salt
water, or organic solvents.
Use with a power supply voltage within ±5% of the rated voltage.
Do not use in water temperatures outside the range of 0–40°C
(32–104°F) which can lead to failure, electrical leakage or shock.
Do not use in the vicinity of explosive or flammable materials.
Use only in fully assembled state.
Note: Consult your local dealer or Wacker Neuson representative
before using with any liquids other than those indicated in this
manual.
3.3.1 Install the pump in a location with sufficient water level, where water
collects readily.
Note: See “Operating Water Level” f or the water level necessary for
operation. The discharge end of the hose should be located higher
than the water surface. If the end of the hose is submerged, water
CAUTION!
Personal injury hazard. Failure to observe this caution can lead to electrical shock,
current leakage, fire, water leakage, or other problems.
 Do not operate this product under any conditions other than those for which it is
specified.
WARNING