Wacker Neuson PS 2 1503, Operator'S Manual

Page: 28 / 50

Maintenance PS (3-Phase) Series
wc_tx000124gb.fm
26
Replacement Parts
The table lists the parts that need to be replaced periodically. Replace
these using the recommended frequency as a guideline.
5.3 Disassembly and Reassembly
Prior to Disassembling and Reassembling
Before disassembling and reassembling the pump, be sure that the
power supply (i.e. circuit breaker) is disconnected, and remove the
cable assembly from the terminal board. To prevent serious accidents,
DO NOT perform a conducting test during disassembly and
reassembly.
Be sure to perform a trial operation when starting the pump after a
reassembly. If the pump was assembled improperly, it may lead to
abnormal operation, electrical shock, or water damage.
This section explains the disassembly and reassembly processes that
are involved up to the casing (or oil casing, in the case of 7.5 kW and
11 kW [10/15 HP] models). Refer to the structural drawing for the
respective model before disassembling. Operations involving the
disassembly and reassembly of the sealing portion (i.e. mechanical
seal) and of the motor require a specialized facility including vacuum
and electrical equipment. For these operations, contact the dealer from
whom you purchased the equipment, or the Wacker sales office in your
area.
PS4 7503HH
PS4 11003HH PS4 7503HF
PS4 11003HF 760 ml (25.7 fl.oz.)
Part Replacement Frequency
Mechanical seal Lubrication oil discolored
Lubricant (SAE 10W/20W) Every 6,000 hours or 12 months, whichever comes first.
Gasket and O-ring Each time pump is disassembled or inspected.
Oil seal (1.5 to 5.5 kW)
[2 to 2.7 HP] Each time pump is disassembled or inspected or if the
sealing lip is worn
Ring-sealing (7.5/11 kW)
[10/15 HP] When it becomes worn.
Sleeve (except 3.7/5.5 kW)
[5 / 7.5 HP] When it becomes worn.
Model Specified Lubricant Capacity
WARNING
CAUTION