Wacker Neuson GPS9700A, Operator'S Manual

Page: 31 / 200

wc_tx004601en.fm
31
GPS9700A Operation
4.7 Use of Extension Cords
When a long extension cord is used to connect an appliance or tool to the
generator, a voltage loss occurs—the longer the cord, the greater the voltage loss.
This results in less voltage being supplied to the appliance or tool and increases
the amount of current draw or reduces performance. A heavier cord with a larger
wire size will reduce the voltage loss.
Damaged extension cords can cause electrical shock, resulting in serious injury or
death. DO NOT use worn, bare, or frayed cords. Replace damaged cords
immediately.
Use the chart below as a guide for selecting proper cable size.
Use only extension cords rated for outdoor use and equipped with a
third-wire ground.
NOTICE : Operating equipment at low voltage can cause it to overheat.
4.8 Recommended Battery
This generator is shipped without a battery. The recommended battery to be used
is:
Current Load in watts Maximum cable length in feet
(Amps) 120V 240V #10 #12 #14 #16
2.5 300 600 1000. 600 375 250
5 600 1200 500 300 200 125
7.5 900 1800 350 200 125 100
10 1200 2400 250 150 100 —
15 1800 3600 150 100 65 —
20 2400 4800 125 75 50 —
Battery Type 22NF
Voltage 12V
Capacity 225 Cold Cranking Amps