Wacker Neuson G 25, Operator'S Manual

Page: 84 / 214

wc_tx003229gb_FM10.fm
84
Mobile Generator
Working with Basler Controller
8.12 Changing the Cooldown Time Setting
Requirements

Machine stopped

Start switch in REMOTE START
Note: Internal programming of the genset controller, or closed connections to a
remote start switch, may cause the machine to start unexpectedly. Be prepared for
the engine to start even with the engine start switch in the REMOTE START
position.
Background The genset controller includes a cooldown timer. The function of the cooldown
timer is to run the engine at no load after a period of being run at load. It is used in
conjunction with the remote start system. The cooldown timer activates when the
machine is no longer receiving a remote run signal. This timer is factory set to zero
(0) minutes. The cooldown time can be changed if desired.
Procedure Perform the procedure below to change the cooldown time setting.
1. Press the right arrow button (1) to access the MAIN MENU.
2. Using the up/down arrow buttons (2, 3) highlight SETTINGS. Then, press the
right arrow button.
3. Highlight SYSTEM PARAMS. Then, press the right arrow button.
This procedure continues on the next page.