BA 1404 en – Edition 2.7 * 1404b210.fm
2-11
Safety instructions
• Ensure that all consumables and replaced parts are disposed of safely and with
minimum environmental impact!
• Do not use the work equipment as lifting platforms for persons!
• Before taking up work on machine parts dangerous for life and limb (bruising, cutting),
always ensure safe blocking/support of these areas.
• Perform maintenance and repair work beneath a raised machine, attachments or
additional equipment only if a safe and secure support has been provided for (the sole
use of hydraulic rams, jacks etc. does not sufficiently secure raised machines or
equipment/attachments).
• Avoid contact with hot parts, such as the engine block or the exhaust system during the
operation of the machine and for some time afterward – burn hazard!
• Remove retainer pins slowly and carefully – injury hazard!
• Using starting fuel is prohibited! This applies in particular if the intake-air preheating is
used at the same time – explosion hazard!
• Apply special care when working on the fuel system – increased fire hazard!
• During maintenance, ensure that there is a fire extinguisher on the job site.
• Before performing (maintenance) work on the machine, remove all jewelry, such as rings,
watches and bracelets. Tie back long hair, and button up or zip up loose-fitting garments.
Injury can result from hair, jewelry or garments getting caught on moving parts!
• Always wear a hard hat and safety shoes when performing work or maintenance on the
machine. If necessary, wear protective clothing, safety glasses, masks, gloves and ear
protectors.
2.14 Warning of special hazards
Electrical energy
• Use only original fuses with the specified current rating!
Switch off the machine immediately, disconnect the battery and rectify the malfunction
if trouble occurs in the electrical system!
• Work on the electrical system may only be performed by a technician with appropriate
training, in accordance with the applicable electrical engineering rules.
• Inspect and check the electric equipment of the machine at regular intervals. Malfunc-
tions such as loose connections or scorched cables must be rectified immediately.
• Observe the operating voltage of the machine/attachments!
• Always remove the grounding strap from the battery when working on the electrical
system or when performing welding work!
• Starting with battery jumper cables can be hazardous if performed improperly. Observe
the safety instructions regarding the battery!
Gas, dust, steam, smoke
• Operate the machine only on appropriately ventilated premises! On enclosed premises
or before starting the internal combustion engine, ensure that there is sufficient venti-
lation!
Observe the regulations in force at the respective site!
• Welding, burning and grinding work on the machine may only be performed by a
Wacker Neuson dealer.
• In areas with special hazards (toxic gases, caustic vapors, toxic environments, for
example), wear appropriate protective equipment (breathing filters, protective clothing)!
Hydraulic system
• Work on the hydraulic equipment of the machine must be performed only by persons
having specific technical knowledge and experience in hydraulic systems!
• Check all lines, hoses and threaded fittings regularly for leaks and obvious damage!
Repair any damage and leaks immediately! Splashed oil can cause injury and fire!
Summary of Contents for E09-01
Page 8: ...1 6 BA 1404 en Edition 2 7 Ba1404en2_7IVZ fm Table of contents...
Page 23: ...BA 1404 en Edition 2 7 1404b110 fm 1 13 Introduction Overview of safety labels...
Page 171: ...BA 1404 en Edition 2 7 1404b560 fm 5 43 Maintenance DIN 51 502 DIN 51 825 1000156007 1...
Page 172: ...5 44 BA 1404 en Edition 2 7 1404b560 fm Maintenance...
