Wacker Neuson BFS 1345, Operator'S Manual

Page: 30 / 42

Maintenance
T01071en.fm
30
7.2 Checking engine oil level
∗
Switch off the engine.
∗
Align the engine bolting level horizontally.
∗
Remove any dirt around the oil level dipstick.
∗
Remove the oil level dipstick and wipe it with a clean, lint-free cloth.
∗
Screw the oil level dipstick all the way back in and pull it out again.
∗
Check: The motor oil level must be between the lower and upper
marks.
∗
If necessary, pour new engine oil into the opening until the upper mark
is reached on the oil level dipstick (see chapter
Technical data for oil
type).
∗
Screw in the oil level dipstick and tighten it by hand.
7.3 Changing the engine oil
The work area should be covered with a waterproof sheet to protect the
floor (protection of the environment).
∗
Align the engine bolting level horizontally.
∗
Bring the engine to a hand warm temperature, either by letting it cool
down or running it until it is warm.
∗
Switch off the engine.
∗
Place a sufficiently large container under the oil drain hose to catch the
used oil.
∗
Remove oil drain hose from the holder.
∗
Remove any dirt around the locking screw.
∗
Unscrew the cap nut.
∗
Let the used oil drain out completely.
Avoid spilling oil. Remove any spilled oil immediately.
∗
Close oil drain hose with cap nut.
∗
Attach oil drain hose to the holder.
∗
Pour new engine oil (see chapter Technical data) into the opening of
the oil level dipstick until the upper mark is reached on the oil level dip-
stick (see
Checking engine oil level ).
∗
Screw in the oil level dipstick and tighten it by hand.
Dispose of the used oil in accordance with the applicable regulations.