Wachs WS-164, User Manual, Page: 25 / 96

Chapter 3, Operating Instructions: Adjusting Clamp Arms for the Pipe Size
E.H. Wachs Part No. 10-010-MAN, Rev. 1-0310 21
Figure 3-4. When you push the wire to deflect it, the
actuator rod will extend.
A
DJUSTING
C
LAMP
A
RMS FOR THE
P
IPE
S
IZE
The clamp arms are attached to the main frame using forked
pins that go through two holes in the frame. Multiple sets of
holes allow the arms to be mounted in various positions.
The hole pairs for each position are stamped with the size of
the largest pipe for that position. Refer to the following sec-
tions for the pipe size settings for each saw model.
WS-164 Pipe Size Settings
Table 1 describes the pipe size settings for the WS-164
model.
Table 1: Pipe Size Ranges for Clamping
Arm Positions—WS-164
Size Stamp Pipe Diameter Range
7 4” to 7” (102-178 mm)
10 7” to 10” (178-254 mm)
13 10” to 13” (254-330 mm)
16 13” to 16” (330-406 mm)