Chapter
5
,
Operating Instructions: Operating the Machine with the Topside Control Unit
E.H. Wachs Company
Part No. 06-150-520-MAN, Rev. 0-0607
49
Figure 5-48. Cut at a slow feed rate until the blade
parts through the wall of the pipe.
6.
After the blade has parted the near wall, you can speed
up the feed rate by adjusting the feed speed lever. You
may need to slow the rate down if you are cutting an
internal casing. Reduce the feed speed if the machine
starts to bind or chatter, or if you see the blade deflect-
ing as it cuts.
7.
As the blade approaches the far wall of the pipe, slow
the feed rate to the setting used at the start. Finish the
cut at this feed rate.
8.
When the cut is complete, move the feed speed lever
back to 0 to stop the feed motion.
Figure 5-49. Stop the feed motion by setting the feed
speed lever back to 0.
Blade
Frame
Oscillating bow
Pipe
Summary of Contents for Goliath Guillotine
