3
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. September, 2016
waclighting.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
Volta 4.5” LED - Downlight Round Trim
R4RD1T, R4RD2T, R4RD1L, R4RD2L
5. Adjust trim assembly to the desired location and lock by using screw driver to secure horizontal adjustable lock (See FIG.11).
6. Raise the invisible trim up to trim assembly until the trim ring is flush to the ceiling cutout. Be sure trim springs mount into slots in trim
assembly (See FIG. 12, 13).
FIG. 11
FIG. 12
FIG. 13
FIG. 14
FIG. 15
FIG. 16
FIG. 17
Horizontal Adjustable Lock
Assembly
Slot
Assembly
Slot
Trim
Spring
Trim
Spring
ACCESSORY INSTALLATION
Trims feature a high and low position. Accessory and accessory holder can be used
with trim in high position.
1. Power off fixture and let fixture cool down.
2. Remove trim from trim assembly (See FIG.14).
3. Raise the heat sink to high position (See FIG.15)
4. Prepare accessory holder with appropriate accessory (See FIG.16).
5. Raise the accessory assembly up into the trim opening, engage the accessory
holder at white tabs of optical cartridge and turn clockwise to lock (See FIG.17).
6. Raise trim up to trim assembly until trim is flash with ceiling surface.
Be sure trim springs mount in appropriate slots in assembly (See FIG.5 & 6).
High Position
Push the heatsink
to high position
Spring Bulge
Make sure the spring bulge
installation into the slot
location
Accessory assembly hold up to (2) accessories
Accessory Holder
Accessory
Assembly
Optical
Cartridge
Heatsink Module
Optical Cartridge
Honeycomb Louver
Accessory
Holder
Cross Louver
Lens
Lens
Accessories
Slot
Low Position
