4
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. September, 2016
waclighting.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
Volta 4.5” LED - Downlight Round Trim
R4RD1T, R4RD2T, R4RD1L, R4RD2L
REFLECTOR AND LED REPLACEMENT
1. Power off fixture and let fixture cool down.
2. Exchange reflector
Note: Not for spot distribution which features dedicated module
a. Remove the trim from the trim assembly (See FIG.14).
b. Inset hand into fixture opening to grip optical cartridge,
rotate to unlock and take out (See FIG.18).
c. Insert replacement reflector into optical cartridge, put the whole assembly back
inside fixture and lock it to the heat sink.
d. Reinstall the trim assembly and trim inside fixture to complete.
3. Replace the LED module (For Narrow, Flood & Wide Beams)
a. Remove trim from the trim assembly first, then the trim assembly from the ceiling
or fixture aperture (See FIG.19).
b. To remove the invisible trim assembly, use the Philips head screw driver to unlock
horizontal lock, then use the flat head screw driver to release the spring tab on
aperture ring (See FIG.20).
c. Remove cap and disconnect power connector and safety cable (See FIG.21).
d. Unlock and remove the optical cartridge and reflector (See FIG.18).
e. Unscrew the LED holder and remove the LED connector from the LED module
(See FIG.22, 23).
f. Remove and discard the LED module from the heat sink.
g. Coat the heat paste (by others or call the factory) on the back of the new LED
module and place it on the heat sink by aligning two holes on LED with two screw
holes on the heat sink.
h. Connect the LED module with connector and fasten the LED holder on top of the
LED model by tightening two screws.
i. Reinstall the reflector and optical cartridge (See FIG.18).
j. Connect power connector and safety cable, then reinstall the trim assembly
and trim inside fixture to complete.
Rotate
clockwise
to lock
Rotate
counterclockwise
to unlock
Trim
Assembly
Horizontal Lock
Connector cap
Heatsink
LED
LED
LED Holder
LED Connector
Screws
Reflector
Optical
Cartridge
Power Connector
Safety
Cable
Spring
Tab
Trim
FIG. 18
FIG. 19
FIG. 20
FIG. 21
FIG. 22
FIG. 23
