Page 6
Remote pairing
Commonly, your remote control will be already paired with your base from the factory, however, if you need to replace
your remote or need to re-pair current remote. Please follow these steps:
1)
Plug in power supply cable to surge
protector or wall outlet. If cable is already
plugged in, disconnect, wait 15 seconds and
plug in again.
2)
Whithin 10 seconds of
powering up the system,
Press and hold
HEAD
DOWN
and
FOOT UP
buttons together.
3)
When pairing is complete, you will hear a beep, if no beep is heard, repeat steps 1 and 2 with a firmer press on
remote’s buttons.
NOTE:
If you need to pair a second base with a second remote, wait 10 seconds or more after the first base was
plugged in before plugging in second base to initiate second pairing process. If you wish to operate both bases with a
single remote, please see section “Base Assembly”, step 8 - Two Base Synchronization.
Connecting Straps
If you are installing two split bases together, you will receive two hook
and look straps with the accessories (one with each base). As optional
step, you can loop these straps around the top and bottom legs that
are closer to next base legs to help in preventing separation or gaps
between the bases. Fasten straps tightly as shown on the diagram and
image on the right.
NOTE:
If your base has push button type adjustable legs,
AVOID
looping the strap over a push button to prevent leg misalignment.
Step 13 - Connecting straps (Split Sizes Only) - Optional installation
Use if you are setting up two Twin XL bases to use with one King size mattress, or when setting up two parts of Split California King base
model with one Cal-King mattress.
