W Box 0E-SB80, Instruction Manual

Page: 10 / 12

Trouble Possible Cause Possible Solution
No sound
Unit not plugged into AC power Check that the rear power switch on the
soundbar is turned on. The LED lights on the
soundbar and on the power supply for the
soundbar should be visible.
Audio cable not properly connected Check cable connections. Replace cable.
Check if connected to proper inputs.
Audio cable not properly connected Connect a phone or other similar device to
the 3.5mm jack on the rear of the soundbar. If
sound is present check all cables, connectors
and source devices. Fault may be with one
of them. If the problem is with the coaxial or
optical digital input then try to use an analog
input. If the analog input works then check the
menu settings in the equipment for 2 channel
or PCM operation.
Master power switch on rear Place master power switch to on.
Front power switch Switch from standby to on
Change to proper input Change from any input back to desired input.
Optical input has 2 channel signal Insure TV/DVD is set to 2 channel audio out.
No audio from subwoofer
Soundbar and subwoofer not matched Repeat match sequence
Volume turned down Turn up sub volume
Remote control not
responding correctly
Remote not directed to receive window Aim remote to receive window on soundbar.
Remote too far from soundbar Move to within 8 meters of soundbar
Remote batteries weak or dead Change batteries
For further assistance please contact us at:
USA 1-800-233-6261
Canada 1-877-234-7378
9
This product conforms to all EU Directive
requirements as applicable by law.