INSTALLATION
Making connections (cont.)
Connecting with BLUETOOTH® devices:
•
Press the BLUETOOTH® button on the remote control until the blue LED on the soundbar
is visible.
•
Take the BLUETOOTH® active device (laptop, phone, tablet, etc) and turn on the BLUETOOTH®
function.
•
Scan for devices and you will find the soundbar.
•
Pair or connect with the soundbar.
•
Play the music as desired.
Connecting the soundbar with the wireless subwoofer:
•
In most cases this is not necessary. The subwoofer is paired with the soundbar from the factory.
However, if necessary take the following steps to connect the soundbar to the subwoofer
wirelessly.
•
Continuously press the Match button on the remote control until the LED is visibly blinking on the
soundbar.
•
While the LED is still blinking on the soundbar, continuously press the button on the rear of the
subwoofer next to the blue LED until the LED starts to blink. Use of a paper clip or similar item
will be necessary to access the button.
•
When the LED on the subwoofer blinks and the LED is still blinking on the soundbar, release the
button on the subwoofer and the two will connect to each other.
•
It may take a few seconds for this connection to be made. Repeat the process as necessary to
make the connection.
Connecting source equipment to an Optical or Coax Digital input on the soundbar:
•
Both digital optical and digital coax inputs on the soundbar support 2 channel or PCM digital
bitstreams.
•
All source equipment must be set to either 2 channel or PCM output.
•
No sound will be present on the soundbar if this setting is not made when the digital optical or
digital coax input is used on the soundbar.
•
If you connect your equipment (satellite/cable box, BluRay player, etc) to your TV via HDMI
cables and then connect the TV to the soundbar via digital coax or digital optical connection
you must set each source device to 2 channel or PCM output.
•
Shown below are some examples of setting source equipment to 2 channel or PCM mode. Most
equipment is similar, please consult your owner’s manual for exact instructions.
•
DirecTV satellite receivers:
o
Select the menu button on the remote control
o
Select settings
o
Select audio settings
o
Under audio settings select Dolby Digital and Select OFF
o
Press exit on the remote
6
Summary of Contents for 0E-SB80
Page 11: ......
