W Box 0E-A100, Manual

Page: 11 / 36

11
Connections
NOTE: Do not connect the AC power cord or turn the amp on until all connections
have been made and confirmed. Making connections with the power on can result
in damage to the amplifier that may not be covered under the factory warranty.
INPUT (0E-A100)
1. Using a stereo or mono RCA-RCA cable with gold ends, connect the LFE OUT, Sub
OUT, or other line level audio OUT on an amplifier, surround receiver or other audio
preamp to the Input on the 0E-A100.
SPEAKER OUT (0E-A100)
1. Use16AWG (min) 2-conductor stranded speaker wire for subwoofer connection.
2. Strip approximately 1/2 to 3/4 of an inch off the ends and twist the strands together so
there are no loose strands that can cause shorts.
3. While observing proper wire polarity, insert the stripped and twisted ends of the
speaker wire into the appro and - terminals. Be sure there are no loose
strands that can cause shorts.
4. Confirm connection and polarity.
5. Connect the speaker wires to the appro and - terminals on the subwoofer.
6. Confirm connection and polarity.
TRIGGER
1. Using a 2 circuit 3.5mm mini plug, c12 to 24VDC from the trigger device
to the striped wire (tip). Connect GND from the trigger device to the unmarked wire
(sleeve).
AC MAINS
1. Selects AC power mode (110VAC/220VAC) before connecting to AC power. Set as
appropriate for geographic location.
2. After all connections have been made connect the supplied AC Power Cord to an
unswitched AC power outlet.
NOTE: Do not connect the AC power cord or turn the amp on until all connections
have been made and confirmed. Making connections with the power on can result
in damage to the amplifier that may not be covered under the factory warranty.