19
PRESSURE WASHER 3000P
2. Release the safety catch on the gun
3. Squeeze the gun trigger to purge the air for a few seconds and start the engine
according to the operating instructions of the engine manufacturer.
Engine start up
!
WARNING
During operation the pressure washer must be
positioned on a firm, stable surface.
Start the engine and follow all safety precautions according to the operating instructions
of the engine section in this manual.
Recommended cleaning procedure
1. Hold the spray gun firmly with two hands and a sturdy stance -- Gun kicks back when
triggered.
2. Dissolve dirt by applying the detergent mixed with water to the surface while still dry.
When dealing with vertical surfaces work from the bottom upwards.
3. Leave the detergent to act for 1-2 minutes but do not allow the surface to dry. Starting
from the bottom, use the high pressure jet at a minimum distance of 30 cm. Do not
allow the rinse water to run onto unwashed surfaces.
4. In some cases, scrubbing with brushes is needed to remove dirt. High pressure is not
always the best solution for good cleaning results, since it may damage some
surfaces. The finest adjustable nozzle jet should not be used on delicate or painted
parts, or on pressurised components (e.g. tyres, inflation valves, etc.).
5. Effective cleaning depends on both the pressure and volume of the water used, to
the same degree.
6. When not spraying, use the spray gun safety catch/safety lock to prevent accidental
high pressure discharge.
Stop the engine
!
WARNING
During operation the pressure washer must be
positioned on a firm, stable surface.
Stop the engine according to the operating instructions in the engine section of this
manual.
1. Run unit with clean water only to purge any chemical or detergent solution in the line.
2. To stop the engine, set the throttle to idle and turn the engine ON/OFF switch to the
“OFF” position.
