VWR VWRC0386A, Instruction Manual

Page: 16 / 94

Scroll for Parameters arrows: Steps the operator
through the parameters of SETTINGS, CALIBRATE
and CONFIGURATION Modes. The right arrow goes
to the next parameter, the left arrow returns to the
previous parameter.
Up arrow: Increases or toggles the parameter value that
has been selected in the SETTINGS, CALIBRATE,
and CONFIGURATION Modes.
Enter arrow: Must press enter arrow key to save to
memory all changed values.
Down arrow: Decreases or toggles the parameter values
that have been selected in the SETTINGS,
CALIBRATE and CONFIGURATION Modes.
Mute key: Press to silence the audible alarm. See
Section 4 for alarm ringback times.
There are two displays on the control panel. The temperature display
shows the temperature in degrees Celsius. The message center displays the
system status (Mode) at all times. The message SYSTEM OK displays
during normal operation. Alarm messages are displayed if the system
detects an alarm condition. See Section 5 - Alarms.
To remove the freezer from the pallet, use a 1/2" wrench to remove all the
bolts securing the shipping bracket to the pallet.
Note
If tipped more than 45°, allow the unit to set upright for 24 hours
before start up.
s
Remove the shipping bracket. Remove the ramp boards from the pallet
and place the slotted end over the ramp brackets on the pallet. The
support blocks on the ramps will be facing down. Before moving the
freezer, make sure the casters are unlocked and moving freely. Align the
caster with the ramp boards. Use adequate personnel to roll the freezer off
the pallet.
Chest Freezer 2-7 VWR International
Section 2
Overview
Displays
Figure 2-10. Message Center
Install Freezer
Panel Keys, Display,
Indicators (cont.)