Instruction Manual INCU-Line Cooled
Page
26
/
32
3.
The device is equipped with a protection mechanism against damaging the cooling system.
The mechanism makes it impossible to turn on cooling when the temperature exceeds 45ºC.
As a result if the device has been programmed to go down with temperature (e.g. from 60ºC
to 20ºC) it may take longer for the program to operate until it reaches 45ºC. The tempera-
ture inside the device is lowered naturally by emitting the heat to the surrounding environ-
ment.
4.
Always make sure that the door has been closed properly!
14 CLEANING AND MAINTENANCE OF THE DEVICE
Before cleaning the device, it needs to be disconnected from the electrical supply!
Maintenance (cleaning of the housing and the chamber) should be carried out at least once a week
(depending on the environmental conditions in the workplace).
To clean products made of stainless steel (INOX) we recommend using cleaning solution dedicated par-
ticularly to stainless steel material. It preserves the steel surface from permanent stains and at the same
time retains aesthetic appearance of the product.
INOX products are made of stainless steel. When used in standard laboratory conditions they do not rust.
However it is possible that stains (which may look like rust) form on the steel surface (e.g. due to the kind
of samples that are incubated in the chamber). In such case we recommend using cleaning solution (to
clean the stains) which is dedicated to this particular application, e.g. Pelox.
14.1 Housing cleaning
1.
The housing and door should be cleaned with caution using a soft cloth dampened with
water.
2
Only mild cleaning products should be used to clean the device.
3.
Electrical parts should not get in contact with water or detergent.
When cleaning stainless steel product with dedicated cleaning solution, one should
pay attention to the suggestions and recommendations given in the user manual (or
in the safety data sheet) of the cleaning solution.
