15
Press the ‘ENTER’ button to confirm.
NOTE: Before running multimode sampling, set the aspirating mode to MULTIMODE (see UTILITY MODE
paragraph)
Starting a multimode sampling cycle
Before running multimode sampling, set the aspirating mode to MULTIMODE (see chapter 4.8.2).
When the sampler aspiration mode is set to MULTIMODE, the main display will alternately show the number of
cycles and the volume of each cycle:
START FOR
MM/DD/YY - HH:MM
NC 02x1000 L.
MM/DD/YY - HH:MM
Press the ‘START’ button to run multiple sampling, the display will show the aspirating volume in the first row and
the residual number of the cycle in the second row:
[ XX]
→
XXX
- 02 CYCLES
At the end of the run, during the interval, the number of “residual cycles” (runs) that are remaining are shown on the
display:
- 02 CYCLES
** D E L A Y **
UTILITY MODE’
With this function it is possible to modify all the settings of the air sampler. The UTILITY MODE is divided into ten
sub menus:
Set time; Mode; Set Autoswitch; Print; Display Record; Clear Record; Language; Identify; Sampling site; Calibration
due.
Always start from UTILITY MODE to reach one of these sub menus. Switch on the instrument and wait until the
main screen is displayed:
START FOR XXX
MM/DD/YY - HH:MM
Press the “
▼
” or “
▲
” arrows to reach the
UTILITY MODE
MM/DD/YY - HH:MM
Press the ‘ENTER’ button, the first sub menu is listed.
ENGLISH
