F.
Ignition modules turn on the main valve
output at pin 5.
G. L1 present at terminal 2 on the main valve
solenoids output and jumpered to LINE IN
at pin 1 on temperature controllers.
Temperature controllers are powered.
3.
Turn temperature knobs to 350°F.
A.
Thermostat cycle lights (red) turn on. The
lights will cycle on/off with the call for heat.
B.
Temperature controller's internal contacts
close (N.O.) and provide L2 (neutral) from
the OUT terminal to terminal 1 for main
burner solenoids on the gas valves.
C.
Main burner solenoids on gas valves are
energized and gas flows to each burner.
Burners light and begin heating griddle.
4.
Griddle will continue to cycle with the
temperature controller until the temperature knob
is turned off; or the power switch is turned off.
GRIDDLE WIRING DIAGRAM
NOTE:
The base model griddle is 24" wide. Each additional 12" griddle section has its own set of identical controls
that are conected using a 12" add on wire harness. Because the components and wiring are identical for each
section, the diagram below can be used for all models.
GRIDDLE WIRING DIAGRAM
VCCG Series Heavy Duty Gas Griddle - ELECTRICAL OPERATION
F45533 (1014)
Page 22 of 26
