REMOVAL AND REPLACEMENT OF PARTS
COVERS AND PANELS
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
There may be multiple circuits. Be sure
all circuits are disconnected.
Top Front Cover
1.
The top front cover is secured with four (4)
screws, two on each side of cover. Remove these
screws then remove the cover from the oven.
Fig. 1
2.
Reverse the procedure to install.
Bottom Front Cover
1.
The bottom front cover is secured with four (4)
screws, two on each side of cover. Remove these
screws then remove the cover from the oven.
Fig. 2
2.
Reverse the procedure to install.
Control Panel
1.
Remove three (3) screws on the right side which
secure the control panel then pull the panel away
from the oven.
Fig. 3
NOTE:
If the oven has a mechanical (KX type)
thermostat, it must be removed from the control panel
first, before removing the control panel.
2.
Disconnect the temperature probe leads from the
solid state temperature control.
3.
Unplug the wire harness connector to the control
panel components.
4.
Reverse the procedure to install.
Right Side Panel
1.
Remove the two screws near front of oven, which
secure the bottom front cover and control panel.
2.
Remove the remaining seven screws securing
the right side panel.
Fig. 4
3.
Pull the right side panel out at the bottom then
down to remove.
4.
Reverse the procedure to install.
Left Side Panel
VC4E & VC6E Series Full Size Electric Convection Ovens - REMOVAL AND REPLACEMENT OF PARTS
Page 7 of 64
F25105 Rev. B (0217)
