Fig. 59
SEQUENCE OF OPERATION
Solid State or Computer, Cooking Control
Refer to schematic diagram AI1709 for Cooking
Control operation.
NOTE:
If using solid shortening, the control should be
programmed to use the melt cycle. In the melt cycle,
the control will cycle the heat on/off in short intervals.
This will gradually heat and liquify the shortening until
it reaches 135°F. Melt cycle default times in seconds
are:
GR Series Gas Fryers with NCC Controls (formerly Tridelta / Built after 3/05) - ELECTRICAL OPERATION
F35660
Rev. A (0717)
Page 38 of
56