4.
Connect lead wires to 1CON and 2CON in noted
positions.
5.
Check steamer for proper operation.
MANUAL DRAIN VALVE
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1.
Remove right SIDE PANEL and REAR PANEL.
2.
Remove pin and washer to disconnect the handle
linkage from linkage bracket.
Fig. 19
3.
Remove nut and linkage bracket.
Fig. 20
4.
Remove drain valve.
5.
Reassemble parts removed in reverse order of
removal.
A.
Apply pipe thread sealant to plumbing
threads before assembly.
6.
Check steamer for leaks and proper operation.
DOOR
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1.
Close door.
2.
Remove left SIDE PANEL.
3.
Remove nuts from upper hinge located inside
front panel.
Fig. 21
4.
Open door slightly, and while holding door, pull
upper hinge away from front panel.
5.
Pull upper hinge out of upper door hinge bushing.
6.
Lift door assembly up and off lower door hinge.
7.
Reinstall parts removed in reverse order of
removal.
8.
Check door for fit and proper sealing of gasket.
DOOR GASKET
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1.
Open door.
2.
Remove the shoulder screws and pan pusher
bracket from gasket plate.
C24EO SERIES ELECTRIC COUNTERTOP STEAMERS - REMOVAL AND REPLACEMENT OF PARTS
F25386 (0415)
Page 10 of 27